Your SUV: Your New Paint Job
Look sharp in cut rate auto body shop or you may lose more than you gain. A good paint job to spruce up your SUV up truck may lose you more than you gain. A good job takes time, skill and equipment.
Why should you pay big dollars to have your SUV repainted when you can get the job done for much less cost? After all for appearances if you place both of these jobs side by side they may well look fine.
In fact, one may be actually be as good as the other – and you will be in the chips with the cheaper job. A low overhead , a low margin of profit and a volume business can make it possible for one shop to charge bargain basement prices and turn out a job that will stand up for years.
But cutting pries may also mean cutting corners. If you have ever painted a car or even a fence you know that a job takes time, patience and a good degree of skill. There are many chances for cutting corners. Failing to sand off rust for instance. Or skipping various steps in the process.
Here are some defects that might show up over time in a corner cutting paint job.
The most common defect is “Peeling”. Peeling is what happens most often. Sometimes the entire paint film lifts off right down to bare metal and you can see rust that was not removed. Or the sealing has not stuck to the primer coat or finish stuck to sealer.
Next in line is wrinkling. Wrinkling is a condition that you can almost always blame on the man or women who did the job. Perhaps too heavy a coat of paint was applied. Or the painter may have used a thinner that dried too fast. In warm weather this will produce a very heavy coat that will surface dry too rapidly. Insufficient thinner is another cause of wrinkling.
Cracking and checking may come from too much haste in turning out the job. Applying finish coasts before the coats underneath dry may well have occurred. Sudden temperature changes or the movement of body panels may cause fine cracks.
Should you take back a defective job like this – the painter may tell you that that “spotting in” would fix it up. It will not. The entire panel must be completely refinished.
Blistering of paint can be caused by a variety of conditions but if it happens soon after the car comes from the auto body shop you can almost always blame the painter.
Poor preparation of the metal always causes blisters and bubbles. Perhaps various steps were missed or fudged. Grease oil or dirt may have been left on the surface before painting began. Moisture or oil in the air line of the spray gun can cause blisters as well.
But if the job is done at a time of high temperature and humidity, be cautious about blaming the shop. These conditions may blister the very best paint job. Even nearby chemical plants or pollution can cause this as well.
How can you avoid such defects and problems? True in even in a full high priced job, some of these defects some or even all of these defects can show up. But your chances of missing them are far better.
Above all, know the shop and its reputation. If you are doubtful stand around awhile and watch. You might well do this while awaiting your estimate.
After all it is your SUV. Your vehicle is the best representation of you. Being careful and thorough is always the best policy.